Control rectangle setup

Control rectangle setup
 
Use this dialog to set bounds of the control's rectangle. This is used to create control screenshots like that shown below.
Double-click the control image to invoke the dialog, then select Edit Control Rectangle in the Image Properties dialog .
 
1

Designer area

1. Designer areaMove and resize the red frame to set bounds of the control's rectangle.
 
 
2

Zoom In\Out

2. Zoom In\Out
Use these buttons to zoom in\out the designer area view.
 
3

Left

3. Left
Specifies the X coordinate of the top left corner of rectangle area.
 
4

Top

4. Top
Specifies the Y coordinate of the top left corner of rectangle area.
 
5

Width

5. Width
Specifies the control rectangle width in pixels.
 
6

Height

6. Height
Specifies the control rectangle height in pixels.
 
7

OK button

7. OK button
Click the button to accept the changes.
 
8

Revert button

8. Revert button
Click the button to discard the changes and restore the initial position of the red frame.
 
9

Cancel button

9. Cancel button
Click the button to discard the changes and cancel the dialog.
 

Created with DrExplain